Aurora Multimedia ICS-SP20 Manual de usuario descargar pdf (Pagina 10)

ICS-SP20 User Manual

7.5 Audio Settings

Volume -- Selects the current (default) volume level

Spatial Effect -- Specifies the strength of 3D-spatial effect

7.6 Tuner Settings

Default Chan -- Specifies the default channel, which will be selected upon ICS-SP20 power-up.

If this default channel is set to “0” -- the default channel will be the last channel

selected before the ICS-SP20 was powered off.

Rename Current Channel

-- Change the text label assigned to the current channel. This label is shown (if

enabled) on screen, along with the channel number, when the ICS-SP20 is

switched to this channel. Display of labels and channel numbers can be globally

disabled on enabled, see the subsequent menu options.

Show Label -- Setting to enable will show up to an 8 character label specific to the channel

when changing channels.

Show Number -- Setting to enable will show up the channel number when changing channels.

Mode -- Select tuner mode (channels allocation) to use, among broadcast and several

cable options.

Tune Channels -- Scans the channels, looking for valid signal presence, and “remembers” which

channels are valid and which are not. This “validity mask” is used then for

channel browsing using channel +/- buttons (so that a user browses through the

defined channels only). Note that before this operation ICS-SP20 must be

connected to RF-antenna or cable TV.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Aurora Multimedia ICS-SP20 Manual de usuario Pagina 10